Moog Servo Valve with 400 bar Maximum Pressure and 0.2-cp Reverse Rotation in Cast Iron or Aluminum Material

D634-394C D634-1009
D634-1010 D634-1011
D634-1012 D634-1013
D634-1014 D634-1015
D634-1016 D634-1018 Flow pressure control electro-hydraulic servo valve MOOG, original from Germany

FAQ:

Frequently Asked Questions (FAQ): Moog Electrohydraulic Servo Valves

1. What is an Electrohydraulic Servo Valve?

An electrohydraulic servo valve is a precision component that acts as an interface between the electrical control system and the hydraulic power system. It receives a low-power electrical analog signal and converts it into a proportional, high-power hydraulic output (flow and pressure). This makes it a crucial control core in electrohydraulic servo systems, responsible for both electrical-to-hydraulic signal conversion and power amplification .

2. How does a Moog Servo Valve work?

A Moog servo valve typically consists of a polarized electrical torque motor and a two-stage hydraulic amplifier .

• First Stage: The torque motor deflects an armature and a flapper attached to it. This flapper moves between two nozzles, creating variable orifices that control the pressure on either end of the second-stage spool .

• Second Stage: The differential pressure moves the spool, which then controls the flow of hydraulic fluid to the actuator. A feedback spring, connected to the flapper and engaging the spool, creates a force that balances the input signal torque, ensuring precise spool positioning proportional to the electrical command .

3. What are the key installation requirements?

Proper installation is critical for performance and longevity.

• Filtration: Install a precision filter with a rating of 5 microns or less upstream of the servo valve. The hydraulic fluid cleanliness should be maintained at a maximum ISO DIS 4406 Code 16/13, with Code 14/11 recommended .

• System Flushing: Before installing the servo valve, the entire hydraulic system must be thoroughly flushed to remove contaminants. Use a flushing manifold and circulate fluid under conditions simulating normal operation .

• Mounting: The valve can be mounted in any orientation, ensuring port alignments match the manifold. The mounting surface should be clean, smooth, and flat. Use the specified screws and torque them to 96 inch-pounds .

• Connections: Use O-ring seal connections (e.g., SAE J1926) and avoid welded fittings. Prefer crimped or 24-degree cone type connections .

400 bar Maximum Pressure Moog Servo Valve

0.2-cp Reverse Rotation Electro-hydraulic Servo Valve

Cast Iron or Aluminum Material Flow Pressure Control Valve

Moog Servo Valve with 400 bar Maximum Pressure and 0.2-cp Reverse Rotation in Cast Iron or Aluminum Material Images